For a better experience on, enable JavaScript in your browser. Thank you!

Combination of dSPACE products

Information as of Release 7.2

Since Release 7.2 all products, including the RCP and HIL Software package, are installed according to a new installation method.

Software packages, e.g. RCP and HIL, TargetLink, ControlDesk Next Generation, are not installed into a common directory anymore.
Thus, in principle, the installation order is not relevant as it was until Release 6.6. (see below).

However, there might be exceptions, for example, it is recommended to deactivate1 a newer software package before installing an older version!

Although the setup programs do not block an installation, only certain combinations of software packages (versions) are allowed to be used on the same PC.
In the documentation this is called run-time compatibility. Below please find the relevant excerpts from the documentation.

1 Using the Installation Manager.

Information for Release 7.0 and 7.1

Starting with Release 7.0 the basic installation methods changed:
In contrast to prior Releases, products installed in different directories can be used without switching (activating) the current installation with the Installation Manager.

For details refer to the documentation excerpts below.

Note that the RCP&HIL Setups from Release 7.1 and 7.0 do not support this new installation strategy. 
For example, RCP&HIL 7.1 can still be installed into the same directory as TargetLink 3.1 from Release 6.5.

Information valid until Release 6.6

If you want to use dSPACE products on the same PC without switching between the active installations using the Installation Manager, all products must be installed in the same base directory.

However, this requires that the products are compatible with each other. The documents to be downloaded below show which products can be installed together in the same directory and in which order they must be installed.

Normally you should use the Master Setup program on the DVD to install combinations of RCP and HIL Software, TargetLink®, and CalDesk®.


For information about software versions not listed in the document below, please contact dSPACE Support.