PS-DINJ 2/1 Patch 1 for Release 5.2 and Release 5.3

Introduction
Problems Fixed by This Patch
Limitations
Installation Notes & Download

Introduction

This patch can be installed on an existing Release 5.2 or 5.3 installation.

Problems Fixed by This Patch

• Problem Report KPR.2007.03.05.001
  The Pick-up output pulse generated by the Injection/Ignition block might be too long. The Pick-up signal might be held at high level until the end of the Hold pulse.
  For details see
  http://www.dspace.com/goto?pr_sfc
• Compatibility with PIC firmware 1.4
  This patch must be installed in order to ensure compatibility between the RPCU_DIAGNOSIS block from the RTIRPCU simulink blockset and PS-DINJ 2/1 modules with module PIC firmware 1.4 or later.
• Additional changes
  The following output port designators of the RPCU_DIAGNOSIS block for the PS-DINJ 2/1 module have been changed while the meaning of these output ports remains unchanged.

• "TA signal timeout" -> "Timeout during peak phase"

• "TB signal timeout" -> "Timeout during hold phase"

Limitations

After installation, models using the RPCU_INJ_IGN_TPU block must be rebuilt. In addition, before starting the build process, the build directory of the model must be deleted.

Installation Notes & Download

ReadMe (2 KB)
RLS_5.2_5.3_RTI_INJIGNp1.exe (1.51 MB)