For a better experience on dSPACE.com, enable JavaScript in your browser. Thank you!

dSPACE FlexRay Configuration Package

The dSPACE FlexRay Configuration Package is used to integrate dSPACE hardware as simulation nodes or monitoring nodes in a FlexRay network. Nodes are configured with the dSPACE FlexRay Configuration Tool according to a communication matrix containing scheduling information for signals and frames transmitted via the FlexRay bus. The communication information is linked to a MATLAB®/Simulink® model by the RTI FlexRay Configuration Blockset. The resulting FlexRay application can be executed on a dSPACE system. The package is an extensive solution for using FlexRay on dSPACE real-time platforms.

In this training course, you will learn how to configure a dSPACE system as a simulation node in a FlexRay network and create application-specific Simulink models. Additional special features such as failure simulation and implementing CRC algorithms are also covered.

  • Function developers and engineers who want to use FlexRay on an RCP or HIL system
  • Control strategy systems engineers
  • Necessary: Experience in using dSPACE products (ControlDesk®, Real-Time Interface or ConfigurationDesk) and MATLAB/Simulink
  • Recommended: Experience with FlexRay

  • Simulate one or more nodes in a FlexRay network
  • Perform restbus simulation

  • dSPACE FlexRay Configuration Package
  • Real-Time Interface (RTI), ConfigurationDesk
  • ControlDesk with Bus Navigator

  • Basic principles of FlexRay
  • Overview of FlexRay hardware and software
  • Workflow of the dSPACE FlexRay Configuration Package
  • dSPACE FlexRay Configuration Tool
  • RTI FlexRay Configuration Blockset
  • Introduction to the ControlDesk Bus Navigator for FlexRay
  • Overview of failure simulation methods
  • Using CRC algorithms

DatesLocation and time
On request
Contact Information