FAQ 810: How Do I Disable ACK Responses in CAN Communication?
Question
Is there a function in Bus Manager that can control whether an ACK is transmitted when a CAN node receives a message?
Solution
No, Bus Manager does not provide a dedicated setting to directly control ACK transmission. However, ACK responses can be suppressed by enabling Low-power mode > Silent mode in the CAN Function Block properties in ConfigurationDesk.
In this mode, the CAN node remains active but it operates in a listen-only state on the bus. As a result, it does not transmit CAN frames and does not send ACK responses.
When enabled, the Mode input port becomes available. Set the Mode input to 2 (Silent mode) from your Simulink model or a TRC variable to place the CAN node into listen-only operation.
However, please note that some channel types (I/O board types) are not supported. Refer to the table below for details.
SCALEXIO
Channel Type |
Bus 1 |
CAN 1 |
CAN 2 |
CAN 8 |
Hardware |
DS2671 | DS2672 | DS6301 DS6341 DS6342 |
DS6302 DS6344 DS6345 |
Low-power mode |
Not Supported | Not Supported | Supported | Supported |
MicroAutoBox 3
Channel Type |
CAN 4 |
CAN 5 |
CAN 6 |
Hardware |
DS1513 | DS1514(DS4342) | DS1521 |
Low-power mode |
Supported | Supported | Supported |
MicroLabBox 2
Channel Type |
CAN 9 |
Hardware |
DS1513 |
Low-power mode |
Supported |
For more details, refer to the "Using low-power mode" section of the following online documentation. (Online document for dSPACE RLS2026-A. For accurate information, refer to the documentation for the release you are using.)
Configuring the Basic Functionality (CAN) - User Documentation - dSPACE
Tags
| Date | 2026-11-05 |
| Information Type | Frequently Asked Questions |