Patch 2.0p2 for dSPACE Release 2.0, Build-No. 1999040901, corrects the following problems:
The patch diskette also contains an update of the DS1103 CAN Firmware 1.0. This update has to be performed by hand.
If you use one or more of these products from CD 2.0, it is recommended that you install Patch 2.0p2. Please remember that you have to reinstall the patch after reinstalling dSPACE software.
NOTE: Do not use this patch for releases other than those stated in the header. If in doubt, make sure that the Build-No. given matches your CD Build-No.
Preparing Patch 2.0p2
Installing the Patch for RTK, RTI CAN, ControlDesk, RTI
Before you can install the patch you must have installed the dSPACE software you want to patch and rebooted your system. You also need to close MATLAB® before invoking the patch.
Installing the DS1103 CAN Firmware Update
To update the DS1103 CAN firmware, follow the steps below. NOTE: Before updating the firmware make sure that your DS1103 is registered.
Download
20p2.exe (448KB)
Date | 1999-05-28 |
Software-Typ | Implementierungssoftware, Experimentier- und Visualisierungssoftware, Bus- und Netzwerk-Software, Steuergeräteschnittstellen-Software |
Produkt | ControlDesk, RCP- und HIL-Software, RTI (Real-Time Interface) |
Informationstyp | Patches |
Informationskategorie | Problembehandlung |
dSPACE Release | Bis 2013-A |
Treiben Sie Innovationen voran. Immer am Puls der Technologieentwicklung.
Abonnieren Sie unser Expertenwissen. Lernen Sie von erfolgreichen Projektbeispielen. Bleiben Sie auf dem neuesten Stand der Simulation und Validierung. Jetzt dSPACE direct und dSPACE direct aeropace & defense abonnieren.