Patch 2.0p2 for dSPACE Release 2.0, Build-No. 1999040901, corrects the following problems:
The patch diskette also contains an update of the DS1103 CAN Firmware 1.0. This update has to be performed by hand.
If you use one or more of these products from CD 2.0, it is recommended that you install Patch 2.0p2. Please remember that you have to reinstall the patch after reinstalling dSPACE software.
NOTE: Do not use this patch for releases other than those stated in the header. If in doubt, make sure that the Build-No. given matches your CD Build-No.
Preparing Patch 2.0p2
Installing the Patch for RTK, RTI CAN, ControlDesk, RTI
Before you can install the patch you must have installed the dSPACE software you want to patch and rebooted your system. You also need to close MATLAB® before invoking the patch.
Installing the DS1103 CAN Firmware Update
To update the DS1103 CAN firmware, follow the steps below. NOTE: Before updating the firmware make sure that your DS1103 is registered.
Download
20p2.exe (448KB)
Date | 1999-05-28 |
소프트웨어 타입 | Implementation Software, Experiment and Visualization Software, Bus and Network Software, ECU Interface Software |
제품군 | ControlDesk, RCP and HIL Software, RTI (Real-Time Interface) |
인포메이션 타입 | 패치 |
인포메이션 카테고리 | Troubleshooting |
dSPACE Release | Prior to 2013-A |
혁신을 추진하세요. 항상 기술 개발의 동향을 주시해야 합니다.
저희 전문 지식 서비스에 가입하세요. dSPACE의 성공적인 프로젝트 사례를 확인해 보세요. 시뮬레이션 및 검증에 대한 최신 정보를 받아보세요. 지금 바로 dSPACE 다이렉트(뉴스레터)를 구독하세요.