CalDesk 1.3p2

Introduction
Problems Fixed by This Patch
Limitations
Installation Notes & Download

Introduction

This patch can only be installed on an existing CalDesk 1.3 installation.

 

Problems Fixed by This Patch

new Feature in CalDesk 1.3p2
CalDesk 1.3p2 introduces support for DS1005-12 and DS1401-18 with new FLASH memory components.

Problems already fixed in CalDesk 1.3p1

• DCI-GSI Device
  Problem with Calibration_Method FixedSizeMoveableEmuRAM using addresses >= 0x 4000 000.
• XCPonUSB
  Additional USB controllers on ECU side supported.
  Contact support.caldesk@dspace.de for further information.
• MCD3 Demo Scripts
  Error concerning project names.
• FormulaManager
  Error on Non-English versions of the operating system.

Limitations

-

Installation Notes & Download

Administrative privileges are required to run the setup program of CalDesk 1.3p2.
CalDesk1.3p2_Update.exe (10 MB)
dSPACE_MC3Client1.3p1_Setup.exe (4.7 MB) *

* You can automate or remote-control CalDesk via a client PC using the CalDesk Automation Module with the ASAM-MCD 3 (DCOM) interface. In this case you must install this client software on the client PC.

When using this patch, it is mandatory to install also a patch for DS1005-12 and MicroAutoBox DS1401-18
regardless of which DS1005 or MicroAutoBox hardware version is actually used.