RapidPro
Integrating automotive sensors and actuators is a key task in rapid prototyping performed for electronic control unit functions. dSPACE’s RapidPro hardware provides unprecedented flexibility in adapting sensor and actuator signals to prototyping platforms (dSPACE MicroAutoBox/AutoBox/MicroLabBox). The RapidPro training gives you a step-by-step introduction to using the RapidPro software and hardware together with a dSPACE prototyping system. You will learn how to configure the RapidPro system with the ConfigurationDesk configuration software and to implement the required I/O with the RapidPro Control Unit Blockset if you work with a RapidPro Control Unit. If you are not familiar with the dSPACE prototyping systems or with the ControlDesk and Real-Time Interface software, it is recommended to request this course in combination with the dSPACE Real-Time Systems course.
- Engineers working with rapid prototyping
- Engineers who want to use the dSPACE prototyping systems and the RapidPro hardware and software
- Required: Experience with MATLAB® and Simulink®, as well as ControlDesk and Real-Time Interface
- Set up RapidPro signal conditioning and power stages Configure the RapidPro Units with ConfigurationDesk
- Learn about the structure and features of the RapidPro system
- Implement the I/O of a RapidPro Control Unit with the corresponding Real-Time Interface
- dSPACE prototyping systems
- Real-Time Interface
- ControlDesk
- RTI RPCU Blockset
- ConfigurationDesk
- MATLAB/Simulink
- Introduction to the RapidPro hardware
- Introduction to ConfigurationDesk
- Monitoring and diagnostics of a RapidPro System
- Introduction to the RapidPro RTI blocksets