For a better experience on dSPACE.com, enable JavaScript in your browser. Thank you!

DS4340 FlexRay Interface Module

Module for interfacing to FlexRay buses

The FlexRay Interface Module can be used with the DS4505 Interface Board or MicroAutoBox II 1401/1505/15071), 1401/1507, 1401/1511/1514 or 1401/1513/1514. The module supports FlexRay protocol specification 2.1 and offers downward compatibility to previous standards. It provides a hardware-configurable, switchable termination circuit. The dSPACE FlexRay Configuration Package is used to integrate dSPACE hardware as simulation or monitoring nodes in a FlexRay network.

Parameter Specification
General
  • 16 timing I/O channels External reset input Interrupt controller
 
  • Supports FlexRay protocol specification 2.1
  • Supports the DS4505 Interface Board or MicroAutoBox II 1401/1505/15071), 1401/1507, 1401/1511/1514 and 1401/1513/1514
  • Automatic detection of Industry Package (IP) for MicroAutoBox and DS4501 or fast COM mode (depending on the carrier board)
  • Molex connectors for direct access to FlexRay bus lines
  • Switchable termination circuit (hardware-configurable)
  • Feed-through possibility for FlexRay bus lines in passive-linear-bus topology
  • Two FlexRay channels
Hardware Details
  • Freescale MFR43xx Communication Controller Family
  • Dual PHY Interface with TJA1080
  • For wake-up, hardware modification of MicroAutoBox and DS4340 is required.2)
  • Requires one slot

1) Can also be used with MicroAutoBox 1401/1505/1506 or DS4501 IP Carrier Board.
2) For more information, please contact dSPACE.

Sujets apparentés