About This Training
The dSPACE FlexRay Configuration Package is used to integrate dSPACE hardware into a FlexRay network as simulation or monitoring nodes. Nodes are configured with the dSPACE FlexRay Configuration Tool according to a communication matrix containing scheduling information for signals and frames transmitted on the FlexRay bus. The communication information is linked to a MATLAB®/Simulink® model by the FlexRay Configuration Blockset. The resulting FlexRay application can be executed on a dSPACE system. The package is an extensive solution for using FlexRay on dSPACE real-time platforms.
In this training course, you will learn how to configure a dSPACE system as a simulation node in a FlexRay network and create application-specific Simulink models. Additional special features such as fault simulation and implementing CRC algorithms are also covered.
This training builds on previous knowledge.
To understand the content of the FlexRay Configuration Package training, you have to complete the Real-Time Systems or the ConfigurationDesk training beforehand.
Do you have questions? Please contact our training department here.
Course Content
- Basic principles of FlexRay
- Overview of FlexRay hardware and software
- Workflow of the dSPACE FlexRay Configuration Package
- dSPACE FlexRay Configuration Tool
- Simulink FlexRay Configuration Blockset
- FlexRay Configuration in ConfigurationDesk
- Introduction to the ControlDesk Bus Navigator for FlexRay
- Overview of fault simulation methods
- Using CRC algorithms
Target Group
- Function developers and engineers who want to use FlexRay on an RCP or HIL system
- Control strategy systems engineers
Requirements
Experience in using dSPACE products (ConfigurationDesk, ControlDesk) and MATLAB®/Simulink®
| Dates | Location | |
| On request | ||
