For a better experience on dSPACE.com, enable JavaScript in your browser. Thank you!

dSPACE Real-Time Systems

This 2-day training course introduces you to the mainfeatures of dSPACE prototyping systems and dSPACE Simulator single-processor systems.
 
Participants
  • Engineers working with rapid prototyping and hardware-in-the-loop (HIL) testing
  • Engineers who are new to dSPACE or who plan to purchase dSPACE prototyping systems or simulator in the near future
  • Recommended: Experience with MATLAB® and Simulink®
Goals
  • Set up dSPACE real-time hardware and corresponding software
  • Implement I/O in Simulink
  • Build real-time code with Real-Time Interface
  • Change parameters and capture data with ControlDesk®
  • Learn advanced features
  • Add bus messages
 
 
Tools and Systems
  • dSPACE single-processor hardware
  • MATLAB/Simulink
  • Real-Time Interface
  • ControlDesk Next Generation
Course Contents
1st Day – Basics
  • Software/hardware setup
  • Introduction to ControlDesk Next Generation
  • ControlDesk platform management
  • Introduction to Real-Time Interface
  • I/O implementation with Real-Time Interface
  • ControlDesk project and experiment management
  • ControlDesk instrumentation
2nd Day – Advanced Features
  • ControlDesk basic data acquisition
  • ControlDesk Table Editor and Data Set Management
  • ControlDesk Bus Communication
  • Multitasking and interrupt handling
  • Programming S-functions

DatesLocation and time Fee per person
October 05 - 06, 2016
Class Full. Registration Closed.
Wixom, Michigan (USA), 8:30AM $ 2000 USD
November 02 - 03, 2016 Wixom, Michigan (USA), 8:30AM $ 2000 USD
December 08 - 09, 2016 Wixom, Michigan (USA), 8:30AM $ 2000 USD
December 13 - 14, 2016 Torrance, California (USA), 8:30 AM $ 2200 USD

  

Contact Information