For a better experience on, enable JavaScript in your browser. Thank you!

dSPACE Release 4.2

The attached list gives you an overview of the innovations of dSPACE Release 4.2.

Product Details
New hardware platform: RapidPro System 1.0
  • Signal conditioning
  • Power stages
  • Intelligent I/O subsystems
ControlDesk® 2.6
  • Steering Controller instrument supporting any type of joysticks and steering wheels with full-force feedback support (feature not supported by Windows NT)
ControlDesk Failure Simulation 1.2
  • Synchronous activation of combined FIU channels on different Mid-Size FIU boards (DS749, DS791)
  • Support of DS793/ DS794 Sensor FIU for dSPACE Simulator Mid-Size DS2211
MotionDesk 2.0
  • Multitrack mode:
  • Time-synchronous replay of simulation scenarios
  • "Transparent" overlaying of vehicles to visualize the differences
  • Automatic generation of "shadow vehicles" to compare simulations
  • Slow motion and fast motion
AutomationDesk® 1.2
  • Report Blocks Library
  • Automation of DTS7
  • Automation of CalDesk 1.1
  • Data container
  • Enhanced capturing
RTI CAN MultiMessage Blockset 1.1
  • Raw data input of a message. It is possible to switch between normal signal input to raw data input online for the entire message.
  • Free identifier. The user can define own message online via identifiers, raw data, cycle time (for TX and RX directions).
  • Capture messages. To capture messages with variable lengths, structures, ...
  • Gateway exclude message list. For online modification of the list of messages which are not to be sent to the other controller.
RTI Bypass Blockset 2.0
  • Extension to the Real-Time Interface (RTI) to Simulink
  • Blockset for dialog-based configuration of bypass applications
  • ASAP2 file browser with filter and search options for the selection of variables
  • Automatic mapping of variable names to addresses in the ECU memory and conversion between phsyical and hex representation
  • Based on the dSPACE Calibration and Bypass Service and the dSPACE XCP Service
  • For DPMEM PODs and XCP on CAN
  • Support of on-chip debug interfaces like AUD/NBD, Nexus and JTAG/OCDS planned via DCI-GSI1 with RTI Bypass Blockset 2.x
  • Bypass interface configuration via ASAP2 (AML) file (no *.m configuration file required)
RTI DS2211 additional features
  • Model switch tool for both directions DS2210 <_-> DS2211
  • Upper frequency range increased to 100 kHz for the PWM channels
  • 2 event capture windows for an engine cycle
  • Flexible handling of engine variants
RTLib functions for support of LIN 2.0 (slave side)
  • Support of DS1005/DS1006 and DS4330
  • Frames
  • Node configuration
  • Event-triggered frame
  • Bus monitor/gateway
Software enhancements for DS1006 Processor Board
  • Faster loading of applications
  • Faster update of boot firmware
  • Use of CDAutomationLib with DS1006 MP systems in network host connection
  • Detection of errors in GigaLink data transfer (also relevant for DS1005-based systems).

Further Information