Patch for RCP and HIL Software Release 2025-A October 2026. ******************************************************************************** Copyright 2026, dSPACE SE & Co. KG. All rights reserved. Brand names or product names are trademarks or registered trademarks of their respective companies or organizations. Contents: 1. General 2. Improvements & Fixed Problems 3. Limitations 4. Installing this Patch 1. General ******************************************************************************** This patch can be installed only on an existing RCP and HIL Software Release 2025-A SP1. 2. Improvements & Fixed Problems ******************************************************************************** This patch implements improvements and fixes the problems as listed below. Model Interface Package for Simulink (MIPS) 25.2.2 - In some cases, when the Model Interface Package for Simulink was used in combination with a ConfigurationDesk version from another dSPACE Release, an error message that no connection to ConfigurationDesk is possible was displayed during the initialization of MATLAB. (Problem Item 1706379) 3. Limitations ******************************************************************************** None 4. Installing this Patch ******************************************************************************** To install this patch, you must be logged on with administrator rights. Close all dSPACE applications and run the setup, which will automatically locate and patch the Software Installation. ********************************************************************************