README file for the ConfigurationDesk 3.0.4 Patch for 
dSPACE RPC&HIL Software 7.0
							                                August 2011

=======================================================================
Copyright (c) 2011 dSPACE GmbH, Germany

-----------------------------------------------------------------------
Contents:

1. Introduction
2. Problems Fixed by This Patch
3. Limitations
4. Installing the Patch


=======================================================================

-----------------------------------------------------------------------
1. Introduction
-----------------------------------------------------------------------
   This patch can only be installed on top of an existing dSPACE
   Release 7.0 installation comprising ConfigurationDesk 3.0.4

-----------------------------------------------------------------------
2. Problems Fixed by This Patch
-----------------------------------------------------------------------
a  Rapid Pro Module DS1634 EGOS
   Summary:
-  A module, configured to support ADV lambda probes, does not show
   the correct lambda probe type in ConfigurationDesk. This
   misbehaviour is fixed with this patch.

----------------------------------------------------------------------
3. Limitations
-----------------------------------------------------------------------

   No known limitations of this patch.


-----------------------------------------------------------------------
4. Installing the Patch
-----------------------------------------------------------------------

   To install the ConfigurationDesk Patch, execute 
   DS_ConfigurationDesk_p1_197317.exe.

   NOTE: You need to close any dSPACE software and MATLAB before
         invoking the installation.

   After installing the patch, you should replace the 'Configuration'
   part of existing ConfigurationDesk applications comprising 
   DS1634 modules. 
   Otherwise it is possible that the wrong probe type is still 
   displayed.
   To replace the 'Configuration' part, select it in the application 
   and open the context menu. Select 'Replace ...' from the context
   menu and in the wizard page select 'based on hardware settings ...'.
   After that the correct lambda probe type is shown in the property 
   dialog.

=======================================================================
End of File