For a better experience on, enable JavaScript in your browser. Thank you!

SCRAMNet+ Interface

Interface to SCRAMNet+ networks

With the SCRAMNet+ Interface, you can connect a dSPACE system to SCRAMNet+ networks. With the interface, dSPACE Simulators and RCP systems can take advantage of the very high speed and deterministic performance of shared memory in a SCRAMNet+ network.

Application Areas

This interface lets you integrate dSPACE Simulators in existing simulator environments where SCRAMNet+ (Shared RAM Network) is the chosen node-to-node communication standard. It enables dSPACE prototyping systems to be the platform for distributed control systems and helps you satisfy high-speed requirements when developing real-time applications. SCRAMNet+ is ideally suited to applications including simulation, telemetry, robotics, data acquisition, instrumentation, industrial process control, digital video, and virtual reality. 

Key Benefits

With a SCRAMNet+ Interface, dSPACE Simulators and RCP solutions can take advantage of the very high speed and deterministic performance of shared memory in a SCRAMNet+ network. SCRAMNet+ interfaces are available for various bus architectures such as VME, PCI, PMC, and CompactPCI, so dSPACE systems can integrate with non-dSPACE systems at high speed and in real time. Since this interface can share data and interrupts, accurate real-time synchronization can be achieved between dSPACE and non-dSPACE systems. Data and interrupts are communicated at memory speeds, a huge improvement over typical message-passing networks. The result is interprocessor communication that is 100% deterministic and very low-latency.

SCRAMNet+ Network

The SCRAMNet+ network is an ultra-fast data communication system designed for use in real-time computer systems. SCRAMNet+ is optimized for the high-speed transfer of small packets of data between computers when low latency data transmission and precise timing are critical.

SCRAMNet+ Blockset

A special SCRAMNet+ Blockset for MATLAB/­Simulink is available for the SCRAMNet+ Interface board. The blockset serves as a graphical interface that lets you configure the SCRAMNet+ node, read from and write to the SCRAMNet+ shared memory, and handle interrupts, both memory- and error-based. This blockset gives you the ability to read and write to SCRAMNet+ memory in two ways: by specifying a starting address and the number of consecutive values to read or write, or by entering one or more addresses as an array that does not have to be sequential.  

Parameter Specification
  • Standard fiber-optic media connectors
  • 1 MB shared SCRAMNet+ memory
  • Auxiliary connector for fiber-optic bypass switch
  • Supports all standard SCRAMNet+ features
  • Status LEDs
Software support

Multiple protocol support:

  • Burst n Burst Plus
  • Platinum
  • Platinum Plus
  • Network timeout support
  • Write-me-last mode support
  • Control of fiber-optic bypass switch
  • Read and write access to entire 1 MB memory
  • Data type handling
  • Network interrupt generation
  • Incoming network interrupt handling
  • Error interrupt generation and handling
  • Memory interrupt generation and handling for each 32-bit location
  • Virtual paging (ability to integrate with any memory configuration)
Supported standards
  • SCRAMNet+
Host interface
  • One 8- or 16-bit ISA slot (for power supply only)
Physical characteristics
  • Full-length ISA board
Ambient temperature
  • 0 … +70 °C (32 … 158 °F)
Power supply
  • +5 V ±5%, 1.36 A



Informations de base